Solar Panel Installation for Vans & RVs in Long Beach | Voltara Systems

Long Beach, CA · (562) 362-3527  

Solar Panel Installation for Vans & RVs in Long Beach | Voltara Systems

The panels are only as good as the install. Wrong penetrations, undersized wire, no fusing — and you've got a system that looks right and fails quietly. We've seen it more than we'd like.

Voltara Systems installs solar panels on vans, RVs, semi-trucks, and boats in Long Beach, CA. Every installation is done properly — sealed penetrations, correctly sized wiring, and integrated cleanly with your existing or new battery and charge controller setup.

What a Proper Panel Install Includes

Roof penetrations sealed against water intrusion. Panels mounted for maximum exposure based on your roof layout. Wiring run in conduit or appropriately protected. MC4 connections made correctly. Every circuit fused. Output tested before you leave.

Sealed Penetrations

Roof cuts sealed against water — done correctly so water intrusion is never a concern down the road.

Correct Wiring

Wire sized for your array output and run length. MC4 connections made correctly. Every circuit fused at the source.

Output Tested

We verify output at each panel and at the charge controller before signing off. No guessing.

Panel Types We Work With

Monocrystalline rigid panels, flexible panels for curved roofs, and bifacial panels where applicable. We'll recommend the right type for your roof geometry and power needs — not whatever we have in stock.

Vans with flat roofs work well with rigid monocrystalline panels mounted on aluminum rails. RVs with curved rubber or fiberglass roofs often benefit from flexible panels. We assess your roof before specifying anything.

Solar panel installation at Voltara Systems follows RV solar installation standards as outlined by the Recreation Vehicle Industry Association. Every install is built to last in mobile environments.

Solar Panel Installation FAQs

It depends on your battery bank size and daily power draw. A basic van setup might need 200–400W. A full-time off-grid RV might need 800W or more. We calculate the right number for your situation during your free consultation.
Yes — both are common on RVs. Penetration method and sealant selection vary by roof material. We know the difference and use the right approach for each type.
No. We plan panel layout around existing roof features — vents, AC units, antennas. Sometimes that means a custom mount solution. It's part of what we do.

Ready to Put Panels on the Roof? Let's Do It Right.

Book a free consultation. We'll assess your roof, calculate your power needs, and give you a clear plan — sealed penetrations, correct wiring, tested output before you leave.

  • ✓ Free roof assessment and load calculation
  • ✓ Works on vans, RVs, semi-trucks, and boats
  • ✓ Rigid, flexible, and bifacial panels available
  • ✓ Every installation tested before handoff

Long Beach, CA · 161 West Victoria Street
(562) 362-3527  WhatsApp · voltara.systems

Book a Free Panel Installation Consultation